Banner M12 Laser Emitters - Manual (Page 2)

M12 Class 2 Laser Emitter Specifications
M12 Class 2 Laser Emitter
2
P/N 52989 rev. C
Banner Engineering Corp. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Supply Voltage and Current 10 to 30V dc (10% maximum ripple) at less than 30 mA
Supply Protection Circuitry Protected against electrostatic discharge (ESD) and transient voltages;
Protected against reverse polarity
Delay at Power-up Less than 30 milliseconds
Sensing Beam 650 nm visible red Class 2 laser (temperature coefficient 0.2 nm/°C);
Pulse Width: 7µs
Rep Rate: 30µs
Peak Output Power: 2.8 milliwatts
Beam Diameter at Aperture Approximately 3.5 mm (0.14") diameter
Beam Divergence ±0.5 milliradians typical at 25°C; ±1.0 milliradian at operating temperature extremes
Beam Placement Within 0.25 mm (0.01") and ±2 milliradians of mechanical centerline axis of housing
Laser Control Apply +10 to 30V dc to black wire to enable beam; Inhibit beam by applying 0V dc or by opening circuit
Enable delay less than 30 milliseconds; Inhibit delay less than 1 millisecond
Indicators Indicators are visible through rear cover.
Green indicates power applied
Yellow indicates laser enabled
Construction 12.7 mm (0.50") diameter smooth aluminum barrel; Black hard-coat anodized finish, MIL-A-8625 Type III, Class II
Environmental Rating NEMA 6; IEC IP67
Connections PVC-jacketed 3-conductor 2 m (6.5') or 9 m ( 30') high-flex cable (unterminated); or
150 mm (6") pigtail with 3-wire Pico-style connector
Operating Temperature Temperature: 0° to 40° C (32° to 104° F); Maximum relative humidity: 90% at 50° C (non-condensing)
Laser Classification Class 2 laser product; complies to 21 CFR 1040.10, EN 60825-1:2001 except for deviations pursuant to
laser notice 50, dated 7-26-01
Certifications