Banner D12 Series - Manual (Page 9)

LED Behavior Problem
LEDs #1 and 7 flash to-
gether 6 times
ON
7
6
5
4
3
2
1
ALM
LO
DO
40 ms
0 ms
Indicator OFF
Indicator ON
Indicator Single-Flash 6 Times
This occurs at the end of TEACH mode when the sensor has received
faulty data. Faulty data may result from an unstable target or from
high electrical noise occurring while TEACH mode is in process. The
sensor returns to Run mode, with the previous setting. Re-teach the
sensor.
LEDs #2 and 7 flash to-
gether
ON
7
6
5
4
3
2
1
ALM
LO
DO
40 ms
0 ms
Indicator OFF
Indicator ON
Indicator Single-Flashing
These LEDs flash continuously to indicate a sensor component fail-
ure. Return the sensor to the factory for replacement.
Accessories
The following table lists all the fiber sizes that can be used with these sensors. Typical fiber models (one for each size and type) are
indicated, along with the maximum range for each (expect less range for fiber assemblies with angled sensing ends). For a complete
selection of fibers in these sizes and for more information see your current Banner Engineering Catalog.
Range data is for 0.9 m (3 ft) glass fiber assemblies.
Glass Fiber - Opposed Mode
IMM.443S Features Sensors Range
Bundle
Diameter
.18 .043
.50 .50 1.0 ± .030
.29
• Fiber diameter: 0.7 mm (0.027 inches)
• Individual fiber
• Stainless steel flexible conduit
• Used in pairs, but sold individually; two are
required
D12E 107 mm (4.2 inches)
IM.753S Features Sensors Range
Bundle
Diameter
.18 .060
.50 .50 1.0 ± .030
.29
• Fiber diameter: 1.2 mm (0.046")
• Individual fiber
• Stainless steel flexible conduit
• Used in pairs, but sold individually; two are
required
D12E 295 mm (11.6 inches)
IT13S Features Sensors Range
Bundle
Diameter
5/16 x 24 Thd Brass
2 Jam Nuts included
.50 .31 1.5
• Fiber diameter: 1.6 mm (0.062")
• Individual fiber
• Thread
• Stainless steel flexible conduit
D12E 442 mm (17.4 inches)
D12 Expert Series - TEACH-Mode Fiber Optic Sensors
P/N 041974 Rev. D www.bannerengineering.com - tel: 763-544-3164 9