Banner PresencePLUS P4 GEO 1.3 Series - Manual (Page 40)

5.4.1 Flexible Inspection Loading
Release 2009R1B introduces a more flexible inspection loading capability that allows most inspections created
by any PresencePLUS vision sensor to be loaded through the PresencePLUS software even if connected to
a different type of PresencePLUS vision sensor. This means that you can now load, for example, an inspection
created by an OMNI 1.3 into PresencePLUS software connected to a standard OMNI. Prior to Release 2009R1B,
inspections could only be loaded into PresencePLUS software that was connected to the same type of
PresencePLUS vision sensor that had created the inspection. In other words, a ProII camera could only load
inspections created by another ProII camera, and an OMNI could only load an inspection saved from another
OMNI, etc.
Note: The one limitation that still exists occurs when trying to load an inspection that uses a
tool that is unavailable (or unlicensed) for the currently connected sensor (for example, attempting
to load to an inspection that uses a Geometric Count tool to a PresencePLUS AREA sensor will
not work because the Geometric Count tool is not supported on the AREA sensor).
P/N 000000 Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Tel: 763.544.3164
40
7/2009 Tools Screen