Banner RP-QM90 Rope Pull Switch - Manual

Datasheet
•
Positive-opening safety contacts (IEC 60947-5-1), not dependent
upon springs
• Contacts latch open when rope is pulled; requires manual reset
• Heavy-duty die cast metal housing, rated IP65, suitable for demanding
industrial environments
• Rope spans up to 100 m (330 ft), with the switch mounted in the center
of the span
• Both safety contacts are closed with normal rope tension, and open when
rope is pulled or if rope breaks (or if tension is reduced from normal
amount)
• Extra contacts for monitoring or to provide dual-channel input to a safety
module
• Switch actuator position clearly indicates when rope has proper tension
for operation
• Long life, switch rated at 1 million mechanical operations, minimum
•
Protective Earth Terminal (IEC 60947-1)
Model Max. Overall
Rope Length
Run Position Cable Pulled
(either side)
Cable Break
(either side)
Switching Diagram
RP-QM90F-100L 100 m (330 ft)
23 24
11 12
11 12
23 24
23 24
11 12
11 12
23 24
23 24
11 12
11 12
23 24
11 - 12 23 - 24
40°
40°
30°
30°
0
Lock
70N
70N
Lock
Lever
11 - 12 23 - 24
Right
Left
Contacts: Open Closed
NOTE: This symbol for a positive-opening safety contact (IEC 60947-5-1) is used in the switching
diagram to identify the point in actuator travel where the normally-closed safety contact is fully open.
Important... Read This First
Regarding the Use of Rope Pull Switches. In the United States, the functions that Banner rope pull switches are
intended to perform are regulated by the Occupational Safety and Health Administration (OSHA). Whether or not any
particular rope pull switch installation meets all applicable OSHA requirements depends upon factors that are beyond the
control of Banner Engineering Corp. These factors include the details of how the switches are applied, installed, wired,
operated, and maintained.
Banner Engineering Corp. has attempted to provide complete application, installation, operation, and maintenance
instructions in this document. Direct any questions regarding the use or installation of rope pull switches to the factory
applications department.
RP-QM90 Series Rope Pull Switches
P/N 62086 Rev. D 4 February 2014
62086