Banner ES-FA-6G Safety Module - Manual

With 3 normally open safety outputs or 2 normally open safety outputs and 1 normally closed auxiliary output
Original Instructions
• Monitors emergency stop devices, such as palm buttons and rope/cable pulls, and posi-
tive-opening safety switches used for guard/gate interlocking
• The safety inputs can monitor:
• A +24V dc source switched by hard/relay contacts in single-channel hookup, or
• Hard/relay contacts in a dual-channel hookup using terminals S11-S12 and S21-S22
• The ES-FA-9AA has three normally open output switching channels for connection to
control-reliable power interrupt circuits
• The ES-FA-11AA has two normally open output switching channels for connection to
control-reliable power interrupt circuits and one normally closed auxiliary output channel
• Automatic reset or monitored manual reset
• Design complies with standards ANSI B11.19, UL991, ISO 13850 (EN418), and ISO
13849-1 (EN954-1) (Safety Category 4)
• For use in functional stop category 0 applications per ANSI NFPA 79 and IEC/
EN60204-1
• 6 or 7 amp safety output contacts, depending on model
• Plug-in terminal blocks
• 24V ac/dc operation
Models Supply Voltage Outputs Output Contact Rating
ES-FA-9AA
24V ac/dc
3 Normally Open (NO) 6 A
ES-FA-11AA 2 Normally Open and 1 Normally Closed (NC) 7 A
WARNING: Not a Stand-Alone Safeguarding Device
This Banner device is not a stand-alone point-of-operation guarding device, as defined by OSHA
regulations. It is necessary to install point-of-operation guarding devices, such as safety light screens
and/or hard guards, to protect personnel from hazardous machinery. Failure to install point-of-operation
guards on hazardous machinery can result in a dangerous condition which could lead to serious
injury or death.
Important: Read this First
The user is responsible for satisfying all local, state, and national laws, rules, codes, and regulations relating to the use of this
product and its application. Banner Engineering Corp. has made every effort to provide complete application, installation, operation, and
maintenance instructions. Please direct any questions regarding the use or installation of this product to the factory applications depart-
ment at the telephone numbers or address found at
http://www.bannerengineering.com .
The user is responsible for making sure that all machine operators, maintenance personnel, electricians, and supervisors are thorough-
ly familiar with and understand all instructions regarding the installation, maintenance, and use of this product, and with the machinery it
controls. The user and any personnel involved with the installation and use of this product must be thoroughly familiar with all applicable
standards, some of which are listed within the specifications. Banner Engineering Corp. makes no claim regarding a specific recommen-
dation of any organization, the accuracy or effectiveness of any information provided, or the appropriateness of the provided information
for a specific application.
Applicable U.S. Standards
ANSI B11 Standards for Machine Tools Safety
Contact: Safety Director, AMT – The Association for Manufacturing Technology, 7901 Westpark Drive, McLean, VA 22102, Tel.:
703-893-2900
ANSI NFPA 79 Electrical Standard for Industrial Machinery
Contact: National Fire Protection Association, 1 Batterymarch Park, P.O. Box 9101, Quincy, MA 02269-9101, Tel.: 800-344-3555
ES-FA-9AA and ES-FA-11AA E-Stop Safety Modules
P/N 060606 Rev. F 2/28/2013
0 060606 6