Banner DUO-TOUCH Run Bar with STB Buttons - Manual

Datasheet
Self-checking ergonomic actuating devices
-RB1E02 without E-Stop
• Ergonomic design for reduced hand, wrist, and arm stresses associated with
repeated switch operation; requires no physical pressure to operate
• Designed to minimize the possibility of defeat and accidental actuation
• Designed to comply with ANSI B11.19 and ISO 13851 (EN 574)
• Robust 13 gauge (0.090") cold-rolled steel construction
• Models available with IP20 or IP65 construction
• Two diverse-redundant microcontroller-based photoelectric STB self-
checking touch buttons:
◦ Continuous internal self-checking operation
◦ Immunity to ambient light, EMI and RFI interference
◦ High excess gain to cut through heavy contamination
◦ LED power, output, and fault indicators
• Emergency stop button on some models
• Designed to be interfaced with DUO-TOUCH SG two-hand control modules
or other control systems that comply, at minimum, with ANSI NFPA 79 or
IEC 60204-1 two-hand control requirements (e.g., anti-tie down)
• Accessory EZ-LIGHT ™ with blue, red, green, and amber LEDs available
• Accessory brackets and telescoping floor-mounted stands available
-RB1E02 with E-Stop
Models Run Bar Description Touch Button
Description
E-Stop Button Connections
STBVP6-RB1
DUO-TOUCH Run Bar,
IP20 metal construction
Two model STBVP6 optical
touch buttons (solid-state
complementary PNP
outputs, polyetherimide
upper housing)
Not included
Terminal strip connection
STBVP6-RB1E02
Model SSA-EBM-02L E-
stop button (two N.C.
safety contacts)
STBVP6-RB1Q8 Not included 8-pin Mini-style QD
STBVP6-RB2
DUO-TOUCH Run Bar,
IP65 metal construction
Not included
Terminal strip connection
STBVP6-RB2E02
Model SSA-EBM-02L E-
stop button (two N.C.
safety contacts)
STBVP6-RB2Q8 Not included 8-pin Mini-style QD
DUO-TOUCH ® Run Bar
Kits
Call for assistance and availability
WARNING: Not a Stand-Alone Safeguarding Device
This Banner device is not a stand-alone point-of-operation guarding device, as defined by
OSHA regulations. It is necessary to install point-of-operation guarding devices, such as safety light
screens and/or hard guards, to protect personnel from hazardous machinery. Failure to install point-
of-operation guards on hazardous machinery can result in a dangerous condition which could
lead to serious injury or death.
Important . . . Read This Before Proceeding!
In the United States, the functions that the Banner DUO-TOUCH Two-Hand Control Module is intended to perform are
regulated by the Occupational Safety and Health Administration (OSHA). Whether or not any particular DUO-TOUCH Two-
Hand Control Module installation meets all applicable OSHA requirements depends upon factors that are beyond the control
of Banner Engineering Corp. These factors include the specific ways the safety module is applied, installed, wired,
operated, and maintained.
DUO-TOUCH Run Bar with STB Buttons
Original Document
131634_web Rev. E
14 March 2014