Banner MAXI-AMP Series - Manual (Page 6)

MAXI-AMP System
Mounting and Accessories
After the panel cutout has been completed and de-burred,
slide the MAXI-AMP through the cutout and place one
clip assembly into the rectangular depression on each
of the two narrow sides of the housing. Orient clips
as shown, and alternately tighten the screws for equal
pressure against the inside of the panel wall. Do not
overtighten the screws. Attach the optional EC11-6
extension cable (described below) to the MAXI-AMP
and route the opposite end of the cable to the RS-11
(or equivalent) socket.
Model EC11-6 extension cable is 6 feet (2m) long.
Clips for panel wall mounting of the MAXI-AMP are
included with the cable.
6
Model RS-11 Socket
The RS-11 is supplied with a coding ring and pin (see diagram at right). This allows a MAXI-AMP to be
keyed to fit only its own 11-pin socket. The pin is installed in one of the eleven slots in the RS-11, and
the notch in the ring is aligned to slip over the pin. When the MAXI-AMP is removed from the RS-11,
the coding ring stays with the MAXI-AMP base, while the coding pin remains in the socket.
Model RS-11 is an eleven-pole round-pin screw
terminal relay socket which is used to make electri-
cal connections to any MAXI-AMP module. The
socket provides in-line wire clamp screw terminals
which will accept from one #24 AWG up to two
#14 wires at each pin. The RS-11 is UL recognized
(file #E92191) and CSA approved (file #LR38486).
It may be mounted directly to a panel plate or via
standard 35mm DIN-rail track (see below). A hold-
down wire is supplied with each RS-11 socket (see
dimension diagram on page 2).
Accessories for MAXI-AMP Modules
35mm DIN Rail Track Model BENC-4 Enclosure
Model BENC-4 is a NEMA-4 rated corrosion-resistant enclosure for a MAXI-AMP
module or other control device. It is supplied with a DIN-35-70 track for easy
mounting of one RS-11 socket. For mounting two sockets, use DIN-35-105.
Panel Wall Mounting of MAXI-AMP Module
Track model DIN-35-70 accomodates one RS-11 socket. Model DIN-35-105
holds two sockets. Model DIN-35-140 holds up to three sockets. The RS-11
socket is designed to snap (or slide) directly into the 35mm DIN track.