Ql55 series luminescence sensor, Specifications – Banner QL55 Series User Manual
Page 6
QL55 Series Luminescence Sensor
6
P/N 112153 rev. C
Banner Engineering Corp.
•
Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Sensing Beam
Ultraviolet high-power LED (370 nm)
Supply Voltage
10 to 30V dc, 2 V pp max ripple
80 mA max, exclusive of load
Supply Protection Circuitry
Protected against reverse polarity
Output Configuration
Discrete NPN or PNP
Analog 0 to 5.5V dc ± 10%, ripple 40 mV pp max.
Saturation Voltage: 1V max. NPN / 2V max PNP
Leakage Current: <100 µA
Output Rating
200 mA maximum load
Output Protection
NPN/PNP: Protected against reverse polarity, overload, and short circuit
(pull down/up resistance 10 kΩ)
Analog: Protected against short circuit (output resistance 2.2 kΩ)
Output Response Time
250 microseconds
Adjustments
2 push buttons (MARK and BKGD) determine switching threshold and Light/Dark operate (see page 3)
2 selector switches (see Figure 5)
• 20 ms Output OFF-delay
• NPN/PNP output
Indicators
Red Output LED
ON:
output is conducting
Green Ready/Overload LED
ON:
normal operating condition, RUN mode
Flashing 2 Hz:
setup failure due to insufficient contrast
Flashing 4 Hz:
output overload condition (verify output current ≤ 200 mA)
Construction
Housing: zinc, aluminum, and magnesium alloy
Lens: glass
Environmental Rating
IEC IP62
Connections
4-pin Euro-style (M12) QD connector. See back cover for required accessory cable options.
Operating Conditions
Temperature:
-10° to +55°C (+14° to +131°F)
Max. Relative Humidity:
85% at 50°C (non-condensing)
Data Retention
EEPROM nonvolatile memory
Scanning Range
QL55M6XD15BQ: 9 to 18 mm (0.35" to 0.71")
QL55M6XD30BQ: 20 to 40 mm (0.79" to 1.57")
QL55M6XD50BQ: 40 to 75 mm (1.57" to 2.95")
Spot Diameter
QL55M6XD15BQ: 2 mm (0.08")
QL55M6XD30BQ: 3 mm (0.12")
QL55M6XD50BQ: 4 mm (0.16")
Ambient Light Rejection
According to EN 60947-5-2
Shock Resistance
30 G; 3 shocks per axis; 11 ms duration
Vibration
0.5 mm (0.02") amplitude; 10 to 60 Hz frequency, 30 minutes for each X, Y, Z axis
Certifications