Banner L-GAGE Q50 Series—Analog - Manual

L-GAGE ™ Q50A Series with Analog Output
LED-Based Linear Displacement Sensor with Analog Output and TEACH-Mode
Programming
Printed in USA 06/01 P/N 67416
L-GAGE Q50A Analog Output Sensor Features
• Fast, easy-to-use TEACH-Mode programming; no potentiometer adjustments
• Selectable output response speeds: 4 milliseconds or 64 milliseconds (see hookup)
• Teach a sensing window size and position, or a 50 mm window centered on a
taught point
• Two sensing ranges, depending on model: 50 to 150 mm (visible red beam
models), and 50 to 200 mm (infrared beam models)
• Sensor linearity is better than 1.5 mm
• Banner’s patented scalable analog output (U.S. patent #6,122,039) automatically
distributes the output signal over the width of the programmed sensing window
• Analog output slope can be either positive or negative, depending upon which
window limit is programmed first
• Two bicolor Status LEDs
• Choose 2 meter or 9 meter unterminated cable, or swivel 5-pin Euro-style QD
connector
• Rugged construction withstands demanding sensing environments; rated IEC IP67,
NEMA 6
• Select models with either visible red or infrared beam
• Select models with either a 0-10V or 4-20 mA output
L-GAGE Q50A Analog Output Sensor Models
Model
Number
Sensing
Range Cable*
Supply
Voltage Beam Output
Q50AVI
50 to 150 mm
(2.0" to 5.9")
5-wire,
2 m (6.5') cable
15 to
30V dc
Visible Red
LED
4 to 20 mA
Q50AVIQ 5-pin Euro-style QD
Q50AVU
5-wire,
2 m (6.5') cable
0 to 10V
Q50AVUQ 5-pin Euro-style QD
Q50AI
50 to 200 mm
(2.0" to 7.9")
5-wire,
2 m (6.5') cable
Infrared LED
4 to 20 mA
Q50AIQ 5-pin Euro-style QD
Q50AU
5-wire,
2 m (6.5') cable
0 to 10V
Q50AUQ 5-pin Euro-style QD
* 9 meter cables are available by adding suffix “W/30” to the model number of any cabled
sensor (e.g., Q50AVI W/30). A model with a QD connector requires a mating cable;
see page 8.
WARNING . . .
Not To Be Used for
Personnel Protection
Never use these products as
sensing devices for personnel protection.
Doing so could lead to serious injury or
death.
These sensors do NOT include the self-
checking redundant circuitry necessary to
allow their use in personnel safety
applications. A sensor failure or
malfunction can cause either an energized
or de-energized sensor output condition.
Consult your current Banner Safety
Products catalog for safety products which
meet OSHA, ANSI and IEC standards for
personnel protection.
!
NOTE: Q50B models also available, with 100 to
400 mm range