Banner SureCross DX81H Battery Supply Module - Manual

Datasheet
• Wireless solution for powering a DX99 FlexPower Node and sensor device in
Class I, Division 1, Groups A, B, C, D; Zone 0, Group IIC environments
• Unique power management system to run the FlexPower Node and a device
through switched power outputs
• Replaceable 3.6 V dc Lithium “D” cell battery
• IP67 sealed enclosure
FlexPower systems allow for a true wireless solution as the Node can be powered by
battery power (3.6 to 5.5 V dc). Battery life is application specific. Contact Banner
Engineering’s application engineers for a battery life calculation for your specific
application.
For additional information, updated documentation, and accessories, refer to Banner Engineering's website,
www.bannerengineering.com/surecross .
Model Power Batteries Cable
DX81H 3.6 V dc battery One 3.6 V Lithium "D" Cell 5-pin Euro pigtail QD
5-pin Euro-Style Female Wiring for DX81H
Only FlexPower ® DX99 devices may be powered from this supply.
5-pin Euro-style Female Connector No. Wire Color Description
1
2
3
4
5
3 Blue dc common (GND)
5 Gray 1 3.6 V dc
Replacing the Battery (DX81 and DX81H Battery Supply Module)
For outside or high humidity environments, apply conductive grease to the battery terminals to prevent moisture and
corrosion buildup.
To replace the lithium "D" cell battery in the DX81 FlexPower ® battery kit, follow these steps.
1. Unplug the battery device from the SureCross device it powers.
2. Remove the four screws mounting the battery pack face plate to the body and remove the face plate.
3. Remove the discharged battery by pressing the battery towards the negative terminal to compress the spring. Pry up
on the battery’s positive end to remove from the battery holder.
4. Replace with a new battery. Only use a 3.6 V lithium battery from Xeno, model number XL-205F.
5. Verify the battery’s positive and negative terminals align to the positive and negative terminals of the battery holder
mounted within the case. Caution: There is a risk of explosion if the battery is replaced incorrectly.
1 Do not apply more than 5.5 V dc to the gray wire.
SureCross DX81H Battery Supply Module
for the DX99
P/N 141517 Rev. B 2 January 2014
0 141517 9