Banner Q45 Namur DC Series - Manual (Page 10)

e) Associated Apparatus is not required for installation of the devices within a Division 2 hazardous (classified) location. The maximum
voltage for Division 2 installation is 15V dc.
f) Maximum connector torque: 6 foot-lbs
CSA Installation Notes
a) Associated Apparatus (barrier) entity parameters must meet the following requirements:
Voc ≤ Vmax
Ca ≥ Ci + Ccable
Isc ≤ Imax
La ≥ Li + Lcable
b) The Associated Apparatus shall not be connected to any device that uses or generates in excess of 250 Volts rms or dc.
c) Intrinsic safety ground, if required for the Associated Apparatus, shall be less than 1 ohm.
d) Installation shall be in accordance with the Canadian Electrical Code, Part 1.
e) Associated Apparatus (barrier) shall be installed in accordance with the manufacturer’s instructions.
f) Associated Apparatus is not required for installation of the devices within a Division 2 hazardous (classified) location when installed in,
or through the wall of a suitable enclosure with provision or connection of rigid metal conduit per the Canadian Electrical Code, as accept-
able to the local inspection authority having jurisdiction. The maximum rating for Division 2 installation is 15V dc, 60 mA.
g) In Division 2 installations, observe the following warnings:
WARNING: Explosion Hazard
Do not disconnect equipment unless power has been switched off or the area is known to be non-hazard-
ous.
WARNING: AVERTISSEMENT: RISQUE D’EXPLOSION
Avant de deconnecter l’equipment, couper le courant ou s’assurer que l’emplacement est designé non
dangereux.
Banner Engineering Corp Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of
shipment. Banner Engineering Corp. will repair or replace, free of charge, any product of its manufacture which, at the time it is returned
to the factory, is found to have been defective during the warranty period. This warranty does not cover damage or liability for misuse,
abuse, or the improper application or installation of the Banner product.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED (IN-
CLUDING, WITHOUT LIMITATION, ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE), AND
WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR TRADE USAGE.
This Warranty is exclusive and limited to repair or, at the discretion of Banner Engineering Corp., replacement. IN NO EVENT SHALL
BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY OTHER PERSON OR ENTITY FOR ANY EXTRA COSTS, EXPEN-
SES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY
PRODUCT DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER ARISING IN CONTRACT OR WAR-
RANTY, STATUTE, TORT, STRICT LIABILITY, NEGLIGENCE, OR OTHERWISE.
Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any obligations or
liabilities relating to any product previously manufactured by Banner Engineering Corp.
Q45 NAMUR Sensors
www.bannerengineering.com - tel: 763-544-3164