Banner K50 Pick-to-Light EZ-LIGHT - Manual (Page 3)

Dimensions
M30x1
(mounting nut included)
max. torque
4.5 Nm (40 lbf in)
½ -14 NPSM
internal threads
50.0 mm
(1.97")
36.8 mm (1.45")*
20.0 mm (0.79")
11.0 mm (0.43")
Ø15.6 mm (Ø0.61")
*For push-button models, this dimension is 44.2 mm (1.74 in)
Specifications
Supply Voltage and Current
12 to 30V dc (10% max. ripple)
< 75 mA max. current at 12V dc (exclusive of load)
< 40 mA max. current at 30V dc (exclusive of load)
ASI compatible
Supply Protection Circuitry
Protected against transient voltages (fast-transient and over-voltage) and re-
verse polarity
Output Configuration
PNP or NPN, depending on model
Output Rating
Max. load: 150 mA
OFF-state leakage current: < 10 µA at 30V dc
ON-state saturation voltage:
< 2V at 10 mA dc; < 2.5V at 150 mA dc
Output Protection Circuitry
Protected against false pulse on power-up and continuous overload or short
circuit of output
Output Response Time
3 milliseconds ON and OFF
Power-Up Output Delay Time
300 ms
Job Light Enable Input
Input impedance: 8K Ohms
Sinking - Input low < 1.5V
Sourcing - Input high > 7V
Construction
Base: polycarbonate
Translucent dome: polycarbonate
Push button: thermoplastic
Lens: polycarbonate or acrylic
Connections
Depending on model: 4-wire, 2 m (6.5 ft) integral cable; 4-pin M12 Euro-style
QD fitting; 150 mm PVC pigtail QD; accessory cordset required for QD mod-
els
Ambient Light Immunity
Up to 5,000 lux
EMI-RFI Immunity
Immune to EMI and RFI noise sources, per IEC 947-5-2
Environmental Rating
Fully encapsulated; IEC IP67
Integral QD models meet DIN 40050 (IP69K) when using IP69K-rated ca-
bles; pigtail and cable models meet IP69K when mounted with conduit
K50 Series Pick-to-Light
P/N 125680 Rev. C www.bannerengineering.com - tel: 763-544-3164 3