Banner WORLD-BEAM QS30 High-Power Opposed Mode - Manual

High-power opposed-mode sensors
Excellent for applications where high sensing
power is required due to long sensing range or
contamination on lenses.
• Infrared beam with high excess gain — range over 213 m (700')
• Excellent noise immunity
• Excellent optical performance throughout the sensing range
• Easy two frequency selection to help prevent crosstalk, see Application Note on
page 3
• Easy-to-read operating status indicators with bargraph display
• Bipolar discrete outputs, PNP and NPN
• Light Operate and Dark Operate models available
• Models available with 2 m or 9 m (6.5' or 30') cable or quick-disconnect fitting
• Tough ABS housing is rated IEC IP67; NEMA 6P; QD models are washdown tes-
ted to DIN 40050-9 (IP69K)
• Unique water/debris-shedding lens design reduces lens contamination; lens mate-
rial survives impact, washdown and cleaning chemicals
• Encapsulated electronics
• Compact housing — mounting versatility via popular 30 mm threaded barrel or
side-mount
Models
Model Cable*
Supply
Voltage
Output Type
Emitters
QS30EX
2 m (6.5') 5-wire
Cable
10V dc to
30V dc
—
QS30EXQ 5-pin Euro-style QD
Receivers
QS30ARX
2 m (6.5') 5-wire
Cable
10V dc to
30V dc
Bipolar NPN/PNP
Light Operate
QS30ARXQ 5-pin Euro-style QD
QS30RRX
2 m (6.5') 5-wire
Cable
Bipolar NPN/PNP
Dark Operate
QS30RRXQ 5-pin Euro-style QD
* 9 m (30') cables are available by adding suffix W/30 to the model number of any
cabled sensor (for example, QS30EX W/30). A model with a QD connector re-
quires a mating cable (see
Cordsets on page 4).
-4.6 m
(-15')
-3.0 m
(-10')
-0.3 m
(-1')
0
0.3 m
(1')
3.0 m
(10')
4.6 m
(15')
0 61 m
(200') 122 m
(400')
183 m
(600')
244 m
(800')
305 m
(1000')
B
E
A
M
W
I
D
T
H
DISTANCE
Figure 1. Beam Pattern
1
10
100
1000
10000
100000
E
X
C
E
S
S
G
A
I
N
DISTANC E
0.3 m
(1') 3 m
(10') 30 m
(100') 300 m
(1000')
Figure 2. Excess Gain
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to serious injury
or death. This product does NOT include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-ener-
gized sensor output condition.
WORLD-BEAM® QS30 Series Sensors
P/N 115011 Rev. E 1/31/2012
0 115011 7