Brother BAS-311F-L - Manual (Page 16)

3. INSTALLATION
BAS-311F-0, 311F-L, 326F-0
9
3-9. Tilting the sewing machine head
BAS-311F-L, 326F-0 : Remove the X feed base cover (1) and the feed base cover support (3) (below) from the machine
head before tapping the head rest (5) (next page) into the work table.
1. Loosen the screws (2) which are holding the X feed base cover L assembly (1) by about 2-3 turns, and then remove
the X feed base cover L assembly (1) in the direction of the arrow in the illustration.
Note
The sewing machine is packed without the X feed base cover L assembly (1) installed.
2. Loosen the screws (4) which are holding the feed base cover support (3) on the left of the sewing machine (when
looking from the front of the sewing machine) by about 2-3 turns, lift the feed base cover support (3) up slightly (BAS-
311F-L) or down slightly (BAS-326F-0), and then remove it in the direction of the arrow in the illustration.
Note
The sewing machine is packed without the feed base cover support (3) installed.
BAS-311F-L BAS-326F-0
(2)
(2)
BAS-311F-L
(3) (4)
(4) (3)
1168S 1169S
(1) (1)
BAS-326F-0
1166S 1167S