Brother BAS-311F-L - Manual (Page 46)

7. SEWING
BAS-311F-0, 311F-L, 326F-0
39
5. Step on the presser lifter switch (6) to raise the presser
foot.
6. Insert the work piece under the work clamp, and press
the presser lifter switch (6) to lower the clamp.
This is convenient when sewing while sitting.
When working with small pieces which are hard to
position, or when precise sewing is required, press the
manual work clamp lifter pedal (7) for precise
positioning of the work piece, and then press presser
lifter switch (6).
7. Press the starting pedal (8).
Note
The work clamp will return to the origin, and will
then advance to the sewing start position and
blinking will stop. This is only required the first time
a program is sewing.
8. Press the starting pedal (8) again to start sewing.
9. After sewing is completed, the thread cutter will
automatically operate, then the work clamp will rise.
Note
When the power is turned on after once being turned off, the same pattern of sewing can be
continued since the machine will stores the sewing data from the last time.
1230S
(8)
(6)
(7)