Brother BAS-311F-L - Manual (Page 45)

7. SEWING
BAS-311F-0, 311F-L, 326F-0
38
7. SEWING
CAUTION
Turn off the power switch at the following times, otherwise the machine may operate if the foot switch is
depressed by mistake, which could result in injury.
When replacing the bobbin and needle
When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result
in personal injury or damage to be machine.
7-1. Before starting sewing....
Check that the needle bar is at its highest position.
Turn the machine pulley so that the index mark (1) on the
pulley is between the marks (2) on the belt cover.
* If the machine is started while the index mark (1) is not
between these two marks (2), error message "E-22"
will be displayed.
(only when memory switch No.14 is on)
7-2. Sewing operation
1. Turn the power switch (1) on.
(The power indicator on the operation panel will light.)
2. Insert the floppy disk (2).
3. Press the PRO. No. selection switch (3) to select the
desired program number.
4. Press R/W switch (4).
The floppy disk drive indicator will light and the
PROGRAM NO. display (5) will show a “P” while
the data is being read. When reading is completed,
an alarm will sound and the indicator will go out,
then the PROGRAM NO. display (5) will blink the
program number.
1228S
(2)
For standard
Yellow
White
For special use
1213S 1229S
(1)
(5)
(3)
(4)
(1)