HK Audio CDR 210 F - Manual (Page 29)

29
D
Figure 13: Mounting the top rigging frame
Figure 15: Setting the curving angle between
COHEDRA® mid/high enclosures
Figure 14: Mounting the main motor to the
top rigging frame
Now connect the back of the top rigging frame to
the enclosure (see Fig. 13).
Important note: For this purpose, the pin must be
inserted through the slot and into the 0 °s position!
Always on the CDR 208 S. See Figure 10.
Attach to the top rigging frame the shackle destined
to accept the motor hook (see Fig. 14).
Your choice of pick point depends on how sharply
you aim to curve the COHEDRA
® mid/high array.
Note: Use the third eyelet (from the front) to set the
array to a curving angle of about 0°.
Check all pins on the top rigging frame to ensure
they are firmly seated and attach the motor to the
shackle.
Hoist the enclosures from the case using the motor
and roll the case off to the side.
Set the pins on the back of the top four mid/high
enclosures in accordance with the desired applicati-
on and curving angle.
This is also a good time to connect the speaker
cables to the four mid/high range enclosures, which
will later be the top cabinets in your array. You can
use the round pole on the top rigging frame to
secure the cables.
Bear in mind that you must attach one of the shack-
les on the top rigging frame to the lashing strap,
chain hoist or motor that will later pull in the back
of the array to curve out its front face. Do this now.
Tip: If you intend to mount additional mid/high
enclosures, it is recommended that you attach all
the required speaker cables to the top rigging frame
now because this task is made more difficult as the
height of the array increases. Be sure to use cables
of sufficient length!
Rigging and Curving COHEDRA ® System