HK Audio CDR 210 F - Manual (Page 66)

Manual
COHEDRA
® & COHEDRA ® Compact
1.2 Display and
Control Features
Limiter LEDs (red)
• Available for each frequency band (HF, MF, LF)
• LED lights up when the Peak Limiter activates in
response to an overload.
• LED also lights up when the temperature limiter of
the given frequency band is active even if it is not
receiving an incoming signal.
Input Level LEDs (8 LEDs: green/yellow/red)
Green: Input level within a range of -24 to 0 dBV
Yellow: Input level within a range of +6 to +12 dBV
Red: Input level higher than +18 dBV
LCD display
• 2 x 16 characters
• In normal operating mode, it indicates the
controller number and selected filter.
• When a menu is accessed, it shows the options
and editable parameters.
Menu button
• Accesses and exits the main menu.
• Selects individual values in windows offering
several variable values.
Enter button
• Accesses windows for editing main menu
parameters.
• Confirms entries and edited values.
+ and - buttons
• Navigate to the next or previous option.
• Edit parameters in the editing window.
Reset button
• Reboots the DFC so that all settings are maintained.
• For further reset functions, see the section Reset
Functions.
Ground switch
On: Grounds the signal to the DFC chassis.
Lift: Severs the connection between the signal and
the DFC's ground. This can eliminate humming
caused by ground loops.
1.3 Basic Settings
Loading stored settings
To load previously programmed and stored DFC
settings, press the Menu button to go to the main
menu and press the + and - buttons to select the
Load Setup window (press - twice). Access the
appropriate editing window by pressing the Enter
button and press the + and - buttons to select a
stored DFC setting from memory slots 1 to 10.
Press Enter to load it to the DFC and return to the
main menu.
Changing the controller number
The controller number is factory-set to Controller
no 1, which is also the default after a hot reset.
HK AUDIO
® DFC PC Software can be used to
assign numbers to DFCs automatically in the se-
quence in which they are looped, or the controller
number can be set manually on the DFC.
To do this, press Menu to access the main menu
and the + and - buttons to select the window for the
option Controller No. (press + eight times). Press
Enter to access the editing window and use the
+ and - buttons to select a controller number from
1 to 32 for this DFC. Confirm your selection and
return to the main menu by pressing Enter.
Selecting the filter for connected speaker(s)
Press the Menu button to go to the main menu
and the + and - buttons to select the window for
the option Speaker Type (press – seven times).
Press Enter to access the Speaker Change editing
window and use the + and - buttons to select one
of the DFC's dedicated speaker filters. Confirm your
selection and return to the main menu by pressing
Enter.
Selecting the audio input
Press the Menu button to go to the main menu
and the + and - buttons to select the window for the
option Audio Input (press – four times). Press Enter
to access the editing window and use the + and
- buttons to select from among the one analog and
three digital options.
Selecting Analog configures the DFC to accept an
analog signal. AES/EBU format is in stereo, so you
have three channels to choose from for patching in
digital signals. Digital Left routes the left channel
of the digital signal to the DFC, Digital Right sends
the right channel. When you select Digital L+R, the
digital left and right channels are blended internally
to create a composite signal. Confirm the selected
option and return to the main menu by pressing Enter.