HK Audio CDR 210 F - Manual (Page 40)

Manual
COHEDRA
® & COHEDRA ® Compact
Figure 3: CDR 108 C with integrated rigging attachments
Figure 4: COHEDRA® Compact standard rigging frame Figure 9: Quick-release pin
Figure 5: COHEDRA® Compact lightweight rigging
frame
Figure 6: Optional quick-release pins for flying up to
six CDR 108 C enclosures
Figure 8: Lashing strap for curving the array in
compression mode
Figure 7: Shackles for attaching motors, straps
3 Components and
Applications of
COHEDRA
® Compact
Rigging Hardware
COHEDRA ® Compact rigging hardware consists of
the following parts:
• a standard rigging frame with two shackles for
attaching motors, lashing straps or chain hoists.
The rigging frame also serves as the base for
ground stacks if the array is not stacked on
CDR 210 C subwoofers.
• an optional lightweight rigging frame for flying
up to eight CDR 108 C enclosures.
• side-mounted, recessed rigging points designed
to accept optionally available quick-release pins
for up to six CDR 108 C enclosures.
• an optional two-part lashing strap for curving the
array in compression mode.
• integrated rigging points on the side and back
for flying COHEDRA ® Compact enclosures
• four quick-release pins per CDR 108 C for
connecting the enclosure to rigging frames.
Important note on pins: Quick-release pins serve to
connect rigging hardware and speaker enclosures,
and their proper function must be tested and verified.
The pins must always engage fully in the (fitted)
hole. Under no circumstances may these pins
release on their own when subjected to tractional
forces. The nib in the center of the pinhead must
always be depressed to insert pins; it releases the
ball detents in front. Once the pin engages in the
hole, the nib must glide back to its initial position.
3.1 Flying Enclosures Using
Quick-release Pins
Small Applications
For small applications (up to six CDR 108 C), you
may use two quick-release pins instead of a rigging
frame. These are inserted into the top enclosure’s
designated side holes. The holes accept 10-mm
pins (see Fig. 6. Be sure to mind the quick-release
pins’ permissible load as well as the manufacturer’s
safety guidelines!
Figure 2: 16 COHEDRA® – CDR 108 C