HK Audio CDR 210 F - Manual (Page 42)

Manual
COHEDRA
® & COHEDRA ® Compact
Figure 14: Setting an interim angle
Figure 15: Mounting the standard rigging frame
Figure 16: Setting the splay to curve a CDR 108 C array
Figure 17: Hoisting the top four
COHEDRA® Compact Enclosures
Figure 18 a: Rigging additional CDR 108 C enclosures
Figure 18 c
Figure 18 b
Note: Depending on application, you may not be
able to select a pick point with a shackle. In this
case, use two shackles and a suitable O ring as
shown in Figure 14.
Check all pins on the top rigging frame to ensure
they are firmly seated and attach the motor to the
shackle.
Important: Ensure the motor’s chain bag hangs fre-
ely and does not rest on the rigging frame!
Remove the two front pins of the lowest enclosure
and fold down its connector component. Now you
can rig the second two-cabinet block. Curve the
four CDR 108 C enclosures as desired for the given
application by setting the pins on the back accordingly
(see chapter 3.1). Determine the desired angle using
the pin labeled Set Angle.
This is also a good time to connect the speaker
cords to the four enclosures that will later be at the
top of the array. Bear in mind that you must attach
one of the shackles on the rigging frame to the lashing
strap or chain hoist that will later serve to pull back
the ends of the array to curve out its front face.
Do this now.
Tip: If you intend to rig additional CDR 108 C en-
closures, it is recommended that you attach all the
required speaker cords to the top rigging frame
now because this task is made more difficult as the
height of the array increases. Be sure to use cords
of sufficient length!
Rigging Additional COHEDRA ® Compact Enclos-
ures
Hoist the mid/ high cabinets to a height that allows
you to roll a second case holding four CDR 108 C
enclosures under the array. Remove the two front
pins from the lowest flown enclosure.
Move the second case with four additional CDR 108
C enclosures into position. Slowly lower the top
four cabinets until the two front connectors engage.
Insert the two front pins first, ensuring that they
engage fully and securely (see Fig.e 18 a). You may
have to shift the two enclosures slightly to ease the
pins into position. In order to attach the rear con-
nector component, you must swivel it out of the rail
so that the round end faces up and the slot faces
down (see Fig. 18 b). To connect the two blocks, in-
sert the pin through the connector’s elongated hole
and through the hole labeled Link.