HK Audio CDR 210 F - Manual (Page 47)

47
D 1
9 Tearing Down and
Transporting the System
As the somewhat clichéd but certainly true adage
goes: To disassemble the system, proceed in the
reverse order of assembly.
These tips should make the task of tearing down the
mid/high array easier:
1 Lower the array until the bottom of the mid/high
case fits under it.
2 Engage the motor or chain hoist to relax the tension
on the strap that is curving the array.
Caution: The array may belly out towards the
front!
3 Disconnect at least the four lower cabinets’ cords.
4 Set the Set Angle pins that are determining the
array’s curving to 0°! This way the array will not
buckle when lowering and setting it on the bottom
of the case. This also makes it easier to dismantle
the four-cabinet block.
5 Always insert the front pins into the holes on the
rigging connector to ensure they are not damaged
or torn off when the array is lowered onto the case!
6 Carefully lower the array into the case. First remove
the rear Link pin connecting the two mid/high
units. Then remove the two front pins. Raise the
array slightly so that the lower four-bin block can
be rolled away.
Rigging and Curving COHEDRA ® Compact System