HK Audio CDR 210 F - Manual (Page 93)

93
1 2
3 4
J
2 Rear Panel Connectors
2.1 Patch Cables for Connecting
the VX 2400 and DFC
DFC Digital In digital audio patch cord
Plug the DFC Digital In cord (a cable with a male
XLR connector located in the bottom opening of the
housing) into the DFC's Digital In. The XLR connec-
tors' pin assignments are:
pin 1 = ground, pins 2 and 3 = signal.
DFC Fullrange In analog audio patch cord
Plug this patch cord (a cable with a male XLR con-
nector located in the upper opening of the housing)
into the DFC's Fullrange In input. The XLR connec-
tors' pin assignments are:
pin 1 = ground, pin 2 = signal (+), pin 3 = signal (-).
DFC LF Out analog audio patch cord
Plug this patch cord (a cable with a female XLR
connector located in the bottom opening of the
housing) into the DFC's LF Out output. The XLR
connectors' pin assignments are:
pin 1 = ground, pin 2 = signal (+), pin 3 = signal (-).
DFC HF Out analog audio patch cord
Plug this patch cord (a cable with a female XLR
connector located in the top opening of the housing)
into the DFC's HF Out output. The XLR connectors'
pin assignments are:
pin 1 = ground, pin 2 = signal (+), pin 3 = signal (-).
Speaker cables
Equipped with Speakon connectors, these speaker
cables connect to the VX 2400's speaker outs (Amp
1 and Amp 2). Please refer to Figure 2. The Speakon
connectors' pin assignments are:
pin 1+ / pin 1-.
Patchbay PB5
3 PB 5 Rack
Configurations
3.1 Power Amp Channel
Routing for a PB 5
Top power amp Channel PB 5 output
Amp 1 A Output Channel 1
Amp 1 B Output Channel 2
Bottom power amp Channel PB 5 output
Amp 2
A Output Channel 3
Amp 2 B Output Channel 4
Use the Mid/High - Sub switch to assign mid/high
or subwoofer signals to any power amp channel.
You have three rack configurations to choose from:
3.2 Mid/High-Sub
In this configuration, one Amp Rack powers
both the mid/ high and subwoofer circuits.
Set the Mid/High - Sub switches of Amp 1 and
Amp 2's A channels to Mid/High mode. Route the
DFC's HF Out (which carries the mid/high frequency
signal) to Amp 1 and Amp 2's Inputs A. The pin
assignments of the NL 4 connectors of Amp 1 and
Amp 2's A Speaker Outs are:
pin 1+ = mid/ high+; pin 1- = mid/ high -.
The LED on the respective switch lights up red.
Set the Mid/High - Sub switches of Amp 1 and
Amp 2's B channels to Sub mode. Route the DFC's
LF Out (which carries the low frequency signal)
DFC's Amp 1 and Amp 2's Inputs B. The pin assi-
gnments of the NL 4 connectors of Amp 1 and Amp
2's B Speaker Outs are:
pin 2+ = sub +; pin 2- = sub -.
The LED on the respective switch lights up green.
Figure 3: Mid/High - Sub