HK Audio CDR 210 F - Manual (Page 30)

Manual
COHEDRA
® & COHEDRA ® Compact
Figure 17 b
Figure 17 c
Figure 17 d
Figure 16: Hoisting the top four COHEDRA® mid/high
enclosures
8 Mounting Additional
COHEDRA
® Mid/High
Enclosures
Hoist the cabinets to a height that allows you to roll
a second case with four mid/high range enclosures
under the array. Remove both front pins from the
lowest flown enclosure and the bottom pin on the
back (see Fig. 16).
Tip: Insert the front pins into the carrying handles
on the sides of the mid/high range enclosure.
This ensures that they are out of the way when the
bottom enclosures are placed in position.
Move the second case with four additional mid/high
enclosures into position. Slowly hoist the top four
cabinets until the two front connectors engage (see
Fig. 17 a). Insert both front pins first, ensuring that
they engage fully and securely. You may have to
shift the two enclosures slightly to ease the pins
into position (see Fig. 17 b). In order to attach the
rear connector component, you must swivel it out
of the rail so that the round end faces up and the
slot faces down (see Fig. 12 a – g for details and
Fig. 17 c)
Tip: Use the motor to slowly hoist the array, creating
a gap of about 60 to 80 mm at the back between
the two enclosures. This makes it easier to insert
the pin into the top enclosure.
Hoist the COHEDRA ® mid/high array with the eight
enclosures just enough to remove it from
the case.
Configure the pins on the back of the bottom four
enclosures to achieve the desired curving angle.
Connect the remaining speaker cables.
Repeat the above procedure to configure even more
mid/high enclosures in a flown stacked array.
Figure 17 a: Mounting additional mid/high enclosures