Tweco A40-A60 CutMaster - Manual (Page 25)

CUTMASTER A40, A60
Manual 0-5120 INSTALLATION 3-1
SECTION 3 SYSTEM:
INSTALLATION
3.01 Unpacking
1. Use the packing lists to identify and account
for each item.
2. Inspect each item for possible shipping dam-
age. If damage is evident, contact your dis-
tributor and / or shipping company before
proceeding with the installation.
3. Record Power Supply and Torch model and
serial numbers, purchase date and vendor
name, in the information block at the front of
this manual.
3.02 Lifting Options
The Power Supply includes hand holds in the front
and rear panels for hand lifting only. Be sure unit is
lifted and transported safely and securely.
!
WARNING
Do not touch live electrical parts.
Disconnect input power cord before moving
unit.
FALLING EQUIPMENT can cause serious
personal injury and can damage equipment.
• Only persons of adequate physical strength
should lift the unit.
• Lift unit by the handles, using two hands. Do
not use straps for lifting.
• Use optional cart or similar device of adequate
capacity to move unit.
• Place unit on a proper skid and secure in place
before transporting with a fork lift or other ve-
hicle.
3.03 Power Supply location and
Mounting
NOTE
It is recommended that the unit be secured to a
suitable surface using the mounting rails.
1. First choose an appropriate location for mount-
ing the power supply. Choose one that allows
for free movement of torch leads, complies
with ventilation per section 2.04 and provides a
safe firm surface where the unit can be secured.
2. Place the unit in the desired position and mark
where the four keyway holes in
the mounting rails touch.
3. Remove the unit and using these markings,
prepare holes for mounting hardware.
4. Insert proper hardware. If using hardware
that screws into the mounting surface, leave
all four loose enough for the thickness of the
rail to slide under the head and washer if used.
5. Lower the power supply over the mounting
hardware and slide forward or backward
until the keyway stops against the mounting
hardware.
6. Secure the hardware to the rail.
3.04 Primary Input Power Connections
CAUTION
Check your power source for correct voltage be-
fore plugging in or connecting the unit. Check
the Voltage Selector at the rear of the unit for
correct setting before plugging in or connecting
the unit. The primary power source, fuse, and
any extension cords used must conform to lo-
cal electrical code and the recommended circuit
protection and wiring requirements as specified
in Section 2.
Most units are shipped from the factory with a 230Volt
input power cable wired to the input contactor in the
single - phase configuration. The following illustra-
tions and directions are for changing that configuration
to a different voltage and or to three - phase operation
or back again if a change had already been made.
A. Cover Removal
1. Remove the upper and lower screws which
secure the cover to the main assembly. Do not
loosen the lower screws inside the cut out slots
in the bottom of the cover.