Tweco 181i Thermal Arc Fabricator User Manual
181i operating manual, Fabricator, 3 in 1 multi-process welding systems
Advertising
Table of contents
Document Outline
- 181i FABRICATOR
- SECTION 1:
SAFETY INSTRUCTIONS AND WARNINGS
- 1.01 Arc Welding Hazards
- 1.02 General Safety Information for Victor CS Regulator
- 1.03 Principal Safety Standards
- 1.04 Symbol Chart
- 1.05 Precautions De Securite En Soudage A L’arc
- 1.06 Dangers relatifs au soudage à l’arc
- 1.07 Informations Générales de Sécurité
- 1.08 Principales Normes De Securite
- 1.09 Graphique de Symbole
- 1.10 Declaration Of Conformity
- SECTION 2: INTRODUCTION
- SECTION 3:
INSTALLATION, OPERATION AND SETUP
- 3.01 Environment
- 3.02 Location
- 3.03 Ventilation
- 3.04 Electricity Supply Voltage
- 3.05 Electromagnetic Compatibility
- 3.06 Victor Regulator
- 3.07 Leak Testing the System
- 3.08 When You Finish Using the Regulator
- 3.09 Storage of the Regulator
- 3.10 Power Source Controls, Indicators and Features
- 3.11 Attaching the Tweco Fusion 180A Gun
- 3.12 Torch Adapter Thumb Screw Replacement
- 3.13 Installing 4" (100mm) Diameter Spool
- 3.14 Installing 8" (200mm) Diameter Spool
- 3.15 Inserting Wire into the Wire Feed Mechanism
- 3.16 Feed Roller Pressure Adjustment
- 3.17 Changing the Feed Roll
- 3.18 Wire Reel Brake
- 3.19 Gas Regulator Operation
- 3.20 Setup for MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.21 Setup for MIG (FCAW) Welding with Flux Core (Gasless) Wire
- 3.22 Setup for SPOOL GUN MIG (GMAW) Welding with Gas Shielded MIG Wire
- 3.23 Setup for LIFT TIG (GTAW) Welding
- 3.24 Setup for STICK (SMAW) Welding
- SECTION 4: BASIC WELDING GUIDE
- SECTION 5: Power Source PROBLEMS AND ROUTINE SERVICE REQUIREMENTS
- SECTION 6: KEY SPARE PARTS
- APPENDIX: FABRICATOR 181i CIRCUIT DIAGRAM