Tweco 181i Thermal Arc Fabricator - Manual (Page 53)

Fabricator 181i
Manual 0-51 91 3-23 INSTALLATION, OPERATION AND SETUP
CAUTION
Loose welding terminal connections can cause overheating and result in the male plug being fused in
the terminal.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
A-09587_AD
MIG Gun
Polarity Lead.
Negative Welding
Terminal (-)
Positive Welding
Terminal (+)
MIG Gun
8 pin Plug
Work Lead
Figure 3-17: Setup for MIG (FCAW) Welding with Flux Cored (Gasless) Wire