Tweco HMC-410 Robotic Interface Kit - Manual (Page 12)

Power Source Robotic Interface Kit Installation
When the robotic interface is to be used with an Arc-Master or Power-Master power source, install the sup-
plied 870210 wire stick voltage supply board into the power source.
To install the 870210 in to the Arc-Master power supply:
(1) Remove power from the Arc-Master power supply
(2) Remove the cover from the Arc-Master power supply
(3) Locate the 204711 control board in the rear deck of the Arc-Master
(4) Locate the J7 connector labeled OPTIONAL WIRE STICK
(5) Place the 870210 board onto that connector, ensuring that the standoffs are properly
latched onto the 204711 board.
(6) Reinstall the cover and power to the power supply
430429-457
2-6 June 13, 2002
Figure 1 Installation of 870210 Board Into Arc-Master