Tweco HMC-410 Robotic Interface Kit User Manual
Page 13
Advertising
To install the 870210 in to the Power-Master power supply:
(1) Remove power from the Power-Master power supply
(2) Remove the cover from the Power-Master power supply
(3) Locate the 830266 control board on the top deck of the Power-Master
(4) Locate the J3 connector labeled OPTIONAL WIRE STICK
(5) Place the 870210 board onto that connector, ensuring that the standoffs are properly
latched onto the 830266 board.
(6) Reinstall the cover and power to the power supply
430429-457
June 13, 2002
2-7
Figure 2 Installation 870210 Board Into Power-Master
Advertising