Tweco 130i Transarc Service Manual - Manual (Page 62)

TRANSARC 130i
DISASSEMBLY PROCEDURE 7-2 Manual 0-5282
7.03 Control PCB Removal
!
Read and follow safety information in Section 6.03 before proceeding with disassembly
Remove case (refer to 7.02) before removing the control board.
1. Remove 2 screws from control PCB.
2 Disconnect WV harness from WV connector.
3. Disconnect GUN harness from GUN connector
4. Disconnect DY harness from DY connector.
5. Disconnect FAN harness from FAN connector.
6. Disconnect QF harness from QF connector.
7. Disconnect MB harness from MB connector.
8. Disconnect OT2 harness from OT2 connector.
9. Disconnect OT1 harness from OT1 connector.
10 Disconnect IFB harness from IFB connector.
11. Disconnect DRIVE harness from DRIVE connector.
12. Disconnect SOURCE harness from SOURCE connector.
Ensure to unplug all harness from the control PCB.
2
3
4
6
1
8
9
10
12
5
7
11
A-11856