Unitec POS4000/V2-Wash Select II - Manual (Page 111)

P O S 4 0 0 0
Document Number: POS4007 85
Document Title: POS4000/V2 WSII Operations Manual
8.1 Programming the Change-Codes Password
The default value for the change-codes password is 23123450. If you want to change this
password, you do so by entering the change-password password, which is 15627470. After the
change-password password has been entered, the interface board will wait for a new change-
codes password to be entered. The change-codes password must end in a 0 may not contain a
0 anywhere else in the password and must be 8 or fewer digits long (including the 0).
Example to make the change-codes password 76543210:
[1][5][6][2][7][4][7][0] (Change-password password)
[7][6][5][4][3][2][1][0] (New change-codes password)
8.2 Programming Backup Customer Codes
The default backup customer codes are 10, 20, 30, 40 and 50. These codes can easily be
changed by entering the change-codes password. After the change-codes password has been
entered, the interface board will beep once and wait for the first customer code to be entered.
After a code is entered, the interface board will beep a number of times to indicate which
customer code should be entered next (2 beeps indicates that the second code should be
entered, 3 beeps indicate the third code should be entered, etc.). If the optional customer display
is connected, messages are displayed to guide you through the 5 codes.
Example to make backup customer codes 110,220,330,440 and 550:
[2][3][1][2][3][4][5][0] (Default change-codes password)
[1][1][0] (Backup customer code # 1)
[2][2][0] (Backup customer code # 2)
[3][3][0] (Backup customer code # 3)
[4][4][0] (Backup customer code # 4)
[5][5][0] (Backup customer code # 5)
Uses of the backup customer codes are recorded by the interface card. When the POS4000
console is operational again and the interface card is placed back in the normal POS4000 mode
of operation, backup code usage is reported to the console and included in the audit reports.