Unitec POS4000/V2-Wash Select II - Manual (Page 126)

P O S 4 0 0 0
Document Number: POS4007 100
Document Title: POS4000/V2 WSII Operations Manual
Recommended procedure for configuration of consoles and bays:
1. Determine the addresses to configure any remote bays or consoles.
2. Power on the main console with the Green communications plug disconnected.
3. Configure the main console as unit 1.
4. Configure the main console as Controller.
5. Configure the Number of Bays and Consoles for the main controller.
6. Leave main console unplugged from the communications cable. Turn off power.
7. If you are using multiple bays, configure their addresses (unit numbers). Reference
POS4000 Interface board wiring diagram in this manual.
8. If you are installing a remote console, continue otherwise skip to step 15.
9. Power on remote console with communications cable unplugged.
10. Configure remote console unit number. Remember the first remote console is unit
number 3 in a single carwash scenario, and unit 4 in a two bay carwash etc).
11. Configure the remote console as remote.
12. Configure the number of bays and remote consoles (remember the number of remote
consoles as programmed into a remote console is always 0).
13. Turn Remote console off.
14. If you have any more remote consoles perform steps 9-13 on each other remote
console.
15. Power up all entry systems.
16. Power up all remote consoles and connect Communications cable.
17. Power up controller (master) console and connect communications cable.
18. Configure the Prices, wash names, code length etc on controller console if not done so
already.
19. Configure the messages for the remote console if you have one.
20. Configure each console linked to an EXT POS.
21. If you are using remote consoles, perform a “Program remote Consoles” command; this
will assure the downloading of important information to any remote console. (See
Section 4.1.11.4)
22. Verify that you can print codes from the remote console and that the ticket Header and
footer messages are correct. Also verify prices on ticket are correct.
23. Verify codes are accepted at all carwash bays.