Unitec POS4000/V2-Wash Select II - Manual (Page 129)

P O S 4 0 0 0
Document Number: POS4007 103
Document Title: POS4000/V2 WSII Operations Manual
Appendix D. Changing the Wash Description Insert Pocket on
Version 2 Style Cases
Preface:
The POS4000 Version 2 style case is designed with a durable membrane keypad with insert
pocket that can be customized to your specific discounts and wash names. The POS4000
comes with a standard generic card loaded into your console keypad. Although any sheet of
paper that is 3.7” wide and 3.6” tall may fit into the pocket, Unitec has provided your unit with 2
sheets that are laser printable with 4 cards on each that may be cut out and used upon
installation.
Replacing or changing Insert pocket card:
1. Remove the 4 screws holding the cover to the metal chassis. Two are located in the rear
and two are located on the bottom front.
2. Fold the top cover forward exposing the bottom side of the plastic cover.
3. The original insert pocket card will be sticking out of a 3.75” slot in the center of the
cover.
4. Remove the insert pocket card and place the new card that you have customized into
the slot. Verify the placement of the card by viewing the front of the keypad before you
continue. You may wish to use a piece of clear tape to hold the insert pocket from
moving over time.
5. Replace the cover and secure the 2 screws in the bottom front first.
6. Install but do not tighten the rear screws through the slotted holes in the rear of the
cover.
7. While pushing down on the top of the keypad, tighten the rear two cover screws.