SARGENT Profile Series Cylindrical Locks - Manual

SARGENT ®
INSTALLATION INSTRUCTIONS FOR 52-2593 KEYPAD SHROUD
FOR USE WITH KP AND PROFILE SERIES ACCESS CONTROL PRODUCTS
For installation assistance,
contact SARGENT at 800-727-5477
or 800-810-WIRE (9473)
KP Series
1. Remove paper backing from gasket, place above keypad escutcheon and
press firmly.
2. Using spacer with mounting holes below centerline as template, mark and
drill three (3) 3/16" x 1/2" deep holes. If anchors are not used, use a #32 size drill.
3. Insert anchors (if required) and complete installation.
Profile Series
1. Mark a level line 1-1/2" above the top edge of the outside escutcheon.
2. Remove paper backing from gasket, place just above the marked line and
press firmly.
3. Place spacer on top of gasket and complete installation from step 2 in
KP Series.
Note: For exterior installations the use of weatherseal gaskets (ordered separately) to seal
between the escutcheon and door is recommended.
KP Series Profile Series
1-1/2"
ANCHORS
(3 PROVIDED)
HINGE
SPACER
MOUNTING SCREWS
#6 x 1-1/2"
(3 PROVIDED)
Optional Weatherseal Gaskets For Outside Escutcheons
68-1400
For use with
8800 or 8900
Profile Series
Exit
Escutcheon
82-0500
For use with
8200 Profile
Series Mortise
Escutcheon
10-0469
For use with
10G77 Profile
Series
52-0254
For use with
KP Keypad
52-0263
For use with
motorized or
solenoid
operated
ET Exit trim
A7670A
GASKET