SARGENT 10 Line Cylindrical Lock - Manual

For assistance, contact SARGENT at 800-810-WIRE (9473) or www.sargentlock.com
10-Line Lock with RX- Switch
Installation Instructions
1. Install latch assembly; do not tighten at this point.
2. Plug ElectroLynx ® connector from the door's raceway to the lockbody’s
connector, being careful not to pinch or damage wires while installing.
3. Install outside lockbody assembly using the through-bolting posts which
are adjustable for various through-bolt locations.
4. Install spacer plate, aligning “Screw Slot” locations with through-bolting
posts, between spring cartridge and the door.
5. Complete installation using A7133.
6. Always test completely to verify installation.
As part of their promise to provide innovative, fast and effective, and
higher security solutions to their customers, ASSA ABLOY Group
companies offer ElectroLynx, a universal quick-connect system that
simplifies the electrification of the door opening.
ElectroLynx ® is a registered trademark of ASSA ABLOY, Inc.
A7886A
Copyright
©
SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.
A7886A 4/2/08 10:45 AM Page 1