SARGENT 7800 Knob Locks User Manual

Rim and mortise cylinders lever /bored locks

Advertising
background image

6, 8 And 9 line locks should be assembled and have

outside knobs locked (by inside knob push or turn button

— or previously by outside knob, key or construction

plug). Then insert control key into replacement core and

turn counterclockwise until stop is reached. Slide core

onto pins and into knob.

THE 11-6300 AND DG1-2-OR 3- 6300 CORES ARE ONLY COMPATIBLE WITH HARDWARE ORDERED

TO ACCEPT THEM, EXISTING HARDWARE MAY REQUIRE TO BE MODIFIED OR REQUIRE THE USE

OF NEW TAIL PIECES IN BORED LOCKS — SEE CATALOG FOR MORE INFORMATION

11-6300 CORES KEYED 1 BITTED USE A CONTROL KEY CUT 113511

BORED LOCKS

Insert control key and

turn counterclockwise

until stop is reached.

With key in this position, pull out core.

To remove key, return to vertical position and withdraw.

Insert control key and rotate

15 degrees counterclockwise

With key in this position, pull out core.

Insert correct tail piece in to

back of core and secure with

tail piece retainer as shown.

INSTRUCTIONS FOR THE REMOVAL AND INSERTION OF

SARGENT CONSTRUCTION CORES, 11-6300 and DG-6300

REMOVABLE CORE CYLINDERS

For assistance, contact SARGENT at 800-727-5477 or www.sargentlock.com

Copyright © SARGENT Manufacturing. All rights reserved. Reproduction in whole or in part without the express
written permission of SARGENT Manufacturing is prohibited.

C

New Cylinder

C

New Cylinder

C

To remove key, return to

vertical position and withdraw.

(Note: for easiest key removal

hold core in place while

starting to withdraw key.)

Note

: if inside

knob button will

not lock knob,

rotate pins in

knob 180°.

Note

: pins in knob should be positioned at

about a 15° angle to align with holes in core.

15°

RIM AND MORTISE CYLINDERS

LEVER /BORED LOCKS

To remove key, return to

vertical position and withdraw.

(Note: for easiest key removal

hold core in place while

starting to withdraw key.)

Make sure that key

clearance slot faces

down.

With pins aligned in housing as shown below, with

control key in core rotate key counter clock wise

and insert core in to housing.

15°

Note: pins should be

positioned at about a 15°

angle to align with holes

in core.

To remove key, return to vertical position and withdraw. (Note: for easiest

key removal hold core in place while starting to withdraw key.)

REMOVING CORE FROM BORED LOCKS

INSTALLING CORES IN BORED LOCKS

6, 8 And 9 line locksets should be

assembled and have outside knobs

locked (by inside knob push or turn

button — or by inside knob key).

Then insert control key and turn

counterclockwise until stop is reached.

With key in this position, pull out core.

To remove key — return to vertical

position and withdraw.

INSERTING CYLINDER CORE

CORE REMOVAL—RIM AND MORTISE CYLINDERS

To remove 60- plastic disposable core pull from lock, save and reuse tail piece in permanent core on bored locks

Install core and tail piece into lock

by inserting control key and rotating

counter clock wise then inserting

core into lock

A5634L

Advertising