SARGENT Profile Series Cylindrical Locks - Manual

Instructions for Using MicroProx ® Proximity Tags with
Low Profile PK and PA Access Control Products
The MicroProx Tag is supplied with a self-adhesive backing which allows it to be
securely attached to any smooth
non-metallic item. This item then becomes an HID
proximity credential similar in operation and function to an HID proximity card or fob.
When the MicroProx Tag is applied to an access control card, follow the suggested
placement locations shown below. If the card is used in a swipe type reader, sufficient
clearance for swipe operation must be allowed. Adequate clearance should be checked
before applying Tag.
Note: The MicroProx Tag is not for use on cards that use full insertion or tractor
feed readers.
MicroProx Placement
Wiegand Swipe Card Contact Smart Chip Magnetic Swipe Card
Tag dimensions are 1.285" diameter x 0.070" thick (32.6mm x 1.8mm)
Note: Each Tag has a unique Identification Number marked on the peel-off paper
backing. Record this number in a safe location before removing the backing.
Attaching Tag to Item:
1. Item must be non-metallic for Tag to operate properly. Metal shields the sensor,
making the Tag inoperative.
2. Surface must be dry, clean and oil/grease free.
3. Remove paper backing and carefully place Tag where desired on item.
4. Caution: Tag is difficult to reposition or remove once attached.
5. Press firmly around edges of Tag to bond adhesive.
For additional information, please contact the SARGENT Electrical Technical Group at
800.810.WIRE (9473).
Magnetic Stripe
Wiegand code strip
(internal)
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7588A