SARGENT 10 Line Cylindrical Lock - Manual

INSTALLATION INSTRUCTIONS FOR
10 Line Lever Lock
(Patents Pending)
For installation assistance, contact SARGENT at 800-727-5477
www.sargentlock.com
Door Preparation
IMPORTANT:
Fold template onto high
edge of door bevel
38" from
Finished Floor
Template
Door
Bevel
DOOR
FRAME
Backset
must match lock
(2-3/8" or 2-3/4")
• All doors should be properly reinforced for lock support. If support is not provided, contact door manufacturer.
• For all metal door preparations use template A4375, EXCEPT for functions 10G70 or 10G71 which uses template 4409
(provided), or functions 10U93, 10U94 and 10U94-2 which require template A4375.
• For all wood door preparations use template A6719, EXCEPT for functions 10G70 & 10G71 which uses template 4409
(provided), or functions 10U93, 10U94 and 10U94-2 which requires template A4375.
• Template information is available on our website, [email protected].
Strike
IMPORTANT: Deadlocking latch must
stop on strike when door is closed
© SARGENT Manufacturing Company
A7133J
• Final Door Prep • Frame Prep for Strike
1 2
3
4
5 6
7
8
4
2
9
10
11
12
13
14
16
17
15 Parts
1. Inside lever
2. Scalp (2)
3. Screws – mounting plate
(2) #6 x 3/4” self-tapping
4. Spacer bushing (2)
5. Inside rose assembly
6. Screws – through-bolt
(2) #10-32 x 1-1/4”
7. Lockbody
8. Outside rose assembly
9. Cylinder spacer
Tools
#2 Phillips screwdriver
Push pin (provided)
7/16” drill bit
1/8” drill bit
2-1/8” bore
1” bore
1
10. Cylinder
11. Outside lever
12. Key
13. Push pin
14. Latch
15. Screws – latch & strike
(4) #8-32 x 3/4”
16. Strike
17. Strike box
Screws (2)
#8-32 x 3/4"
Centerline of
latch front and
strike
Outside of Door
(secured side)
Inside of Door
• Mark and Drill Holes
2-1/8"
(54mm)
hole
5/32"
(4mm)
1-1/8"
(29mm)
2-1/4"
(57mm)
7/16" (11mm) hole 1"
(25mm)
hole
* Used with 68 Function only