SARGENT Passport 1000 P2 Cylindrical Lock User Manual

Description (fig. 1), Route electrolynx cable through the door, Route connector and ground wire (fig 3)

Advertising
background image

05/30/10

Copyright © 2010, Sargen

t Manufacturing Company

, an A

SS

A AB

LO

Y G

roup company

. All right

s reser

ved

.

Reproductions in whole or in par

t without express writ

ten permission of Sargen

t Manufacturing Company is prohibited

.

A8039A 1

Auxiliary Power Cable Instructions

For Hard Powering Passport 1000
P2 Installations (91- Option)

FOR INSTALLATION ASSISTANCE CONTACT SARGENT • 1-800-810-WIRE (9473) • www.sargentlock.com

SECTION I: OVERVIEW

1.

Description (Fig. 1).

The auxiliary power cable (P/N 52-4029) is intended for use in Passport 1000 P2 installations when AA batteries
are not used as the primary power source. It is intended only for use when connecting through an ElectroLynx™
harness to Sargent 3267 power supplies.

SECTION II: INSTALLATION PROCEDURE

1. Route ElectroLynx cable through the door.

Install cable while installing the door harness and lock assembly.

Note: This step is only necessary when not using a pre-wired door.

2.

Connect auxiliary power cable to 8-pin ElectroLynx cable (Fig. 2).

Notes:
Connectors go on only one way.

• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).

3.

Route connector and ground wire (Fig 3).

Keep ferrite behind the fire plate and bring power

connector and ground wire to the front.

4.

Fasten ground wire and motor ground wire (Fig. 3).

• Fasten ground wire along with motor ground wire

using lower right escutcheon screw.

5.

Connect Hirose connector to circuit board (Fig. 4).

• Plug power connector to back of circuit board.
• Snap housing into place.

ElectroLynx Connector

Power Connector

Ground Wire Lug

Ferrite

Fig. 1

Fig. 3

Power
Connector

Ground
Wire Lug

Mounting Plate

3

4

ElectroLynx

Connector

2

Fig. 2

1

Inside of Door

Outside of Door

Power

Connector

5

Fig. 4

Auxiliary Power Cable

(P/N 52-4029)

Advertising
This manual is related to the following products: