Great Plains 3S-4010HDF Operator Manual - Manual (Page 18)

14 3S-4010HD and 3S-4010HDF Great Plains Manufacturing, Inc.
196-522M 03/28/2012 E
Refer to Figure 5
1.
Adjust the drill hitch to match your tractor-drawbar
height, using crank of tongue jack on side of tongue.
Note: The precise height is not critical, as the drill leveling
is set at the mainframe and is independent of
tongue level.
Note: The hitch may be mounted inverted if necessary,
but always have two (2) bolts in two holes of both
tongue and hitch.
2. Securely attach safety chain to an anchor on a trac-
tor capable of pulling the drill.
FigureSpacer:
Refer to Figure 6
3.
Use crank to raise jack foot. Remove pin and jack.
4. Store jack on top of tongue.
FigureSpacer:
Figure 5
Drill Hitched
20273
FigureSpacer:
100% Figure 6
Jack in Storage Location
20272