Clutch/point row operation, Normal full pass, Point row – Great Plains 3S-4010HDF Operator Manual User Manual
Page 36: Calibration, Normal full pass point row calibration, Eclutch/point row operation

32
3S-4010HD and 3S-4010HDF
Great Plains Manufacturing, Inc.
196-522M
03/28/2012
E
Clutch/Point Row Operation
Prior to first use, the controller module must be installed
in the tractor cab. See “Install Clutch Switch Module in
Cab” on page 106.
During normal full-swath planting, the console requires
no attention; all switches except Pump are On.
Common tasks requiring switch changes are:
• Calibration
• Point Row planting.
Normal Full Pass
1.
Set Master switch
ON (up), and Pump
OFF.
Set all sections
ON (up).
Check that corresponding lamps are on.
2.
Height switch automatically energizes clutches when
row units are lowered.
Point Row
3.
Turn desired sections off as non-planting regions are
reached.
4.
Turn them back on before commencing next full-
width pass.
See also see “Clutch Troubleshooting” on page 59.
Calibration
In order to work at a comfortable height, the drill is nor-
mally lowered for calibration. If power is on, the clutches
will be engaged, preventing manual operation of the
metering system with the calibration crank.
For calibration of a drill section, set the Master switch
down to center-OFF. This disengages all clutches.
Refer to the Seed Rate Manual for details on calibration.
FigureSpacer:
FigureSpacer:
FigureSpacer:
FigureSpacer:
Figure 34
Cab Switch Box
28097
Switch
or
Indicator
Function
MASTER
Switch
Up: System enabled
Center: System OFF
Down: Height Switch Bypassed ON
MASTER
Lamp
On: System enabled
Off: System OFF
Section
Lamps
On: Clutch energized for that section.
Off: Clutch not energized
a
a. However, the section’s meters may still be coupled to the
drive system, if lock-up bolts are installed in the clutch.
LEFT
CENTER
RIGHT
Up: section enabled
Down: section disabled
PUMP
No function on standard 3S40 drills.
Fuse
b
b. If
lamp fails to illuminate with
set ON, check the
fuse
. If open, check for damaged cable / failed clutch.
Protects switch box, clutches and
battery.
CAL
Switch
and Lamp
Height switch overridden to ON
M
m
S
L
C
R
P
F
m
M
F
CAL
M
R
C
L
CAL
F
S
P
m
{
M
P
L C R
M