Great Plains 3S-4010HDF Operator Manual - Manual (Page 66)

62 3S-4010HD and 3S-4010HDF Great Plains Manufacturing, Inc.
196-522M 03/28/2012 E
Small Seeds Box Clean-Out
1. Open lid of each box and scoop out as much seed as
possible.
2. To recover remaining seed, place a collection tarp
under the small seeds tubes at the openers.
3. Raise drill.
4. Set seed rate handles to 100.
5. Rotate clutch shaft until no seed flows.
6. If a vacuum cleaner is available, remove any residual
seed from top of meters.
Seed Flap Replacement (s/n B1010B-)
Refer to Figure 72
To replace a seed flap
use a needle nose pliers or
similar tool and squeeze the tabs together. Pull plastic
seed flap down out of metal bracket .
If replacing with 817-349C:
Push new seed flap
up through metal bracket until
tabs on seed flap snap in place.
If replacing with 816-302C:
See seed flap replacement instructions below.
Seed Flap Replacement (s/n B1011B+)
Refer to Figure 73
To replace an 816-302C seed flap
use a needle nose
pliers or similar tool to grasp “T” top of flap. Pull upward
to pull flap up out of metal bracket
.
Push new seed flap down through metal bracket
until flap snaps into place with “T” top resting on top of
bracket.
FigureSpacer:
Figure 72
817-349C Seed Tube Flap
19398
3
2
1
2
1
2
1 3
1 3
2
4
5
Null4:
Figure 73
816-302C Seed Tube Flap
31047
4
5
4 5