Coulter spring length – Great Plains 1007NT Operator Manual User Manual

Page 35

Advertising
background image

Great Plains Manufacturing, Inc.

Adjustments

31

10/06/2010

150-290M

Coulter Spring Length

Coulter springs are preset at 10in (25.4cm), giving
coulters an initial operating force of 400 pounds before
the spring compresses. This setting is adequate for
many difficult no-till conditions.

In normal operation at target running depth, springs are
at full extension or only slightly compressed. They com-
press briefly at obstructions and in denser soil.

• In heavy no-till conditions, you may observe the

springs in compression most of the time. This means
that the blades are not reaching the desired coulter
depth. If adequate drill weight is available, you can
increase the spring down-force to compensate.

• In light but rocky conditions, the factory setting may be

higher than needed. Extend blade life by reducing the
force at which the blades ride up over obstructions.

To adjust the coulter spring:

Refer to Figure 19
1.

Raise the drill and install transport locks. See “Drill
Lift/Lower
” on page 18.

2.

Determine the new spring length

desired. See the

table at right.

3.

Measure the current length of the spring(s) to be
changed. If already shorter than 9

3

4

in, or longer than

10

1

4

in, do not further adjust them.

4.

Loosen the jam nut

.

5.

Rotate the adjuster nut

until the spring is at the

new length. Tighten the jam nut.

Note: If all springs are continuously in compression, the

coulters can lift the drill off the ground (at the
ground drive wheels), resulting in low seeding rates
and uneven seed depth. If high forces are required,
frame weights are probably required.

Resetting coulter-spring length shorter than 9

3

4

in may cause

premature failure of parts, and voids the warranty. No 1007NT
configurations have enough weight to compress all springs
shorter than 9

3

4

in.

Figure 19

Coulter Spring

27139

Spring Length

Force at Blade

10.50 in (26.7 cm)

175 lbs (79 kg)

10.25 in (26.0 cm)

300 lbs (136 kg)

10.00 in (25.4 cm)

400 lbs (181 kg)

9.75 in (24.8 cm)

525 lbs (238 kg)

1

1

3

2

1

2

3

Advertising