Great Plains NTA2007 Operator Manual - Manual (Page 42)

38 NTA607 or NTA2007 Table of Contents Index Great Plains Manufacturing, Inc.
166-372M Table of Contents Index 2012-01-05
Fold: Verify Lift Lock
Refer to Figure 27
9.
Inspect the centre section lift lock to ensure that:
9a. lock cylinder
is extended, and
9b. lock lug is below the lock plate post tops .
If the cylinder is extended, but the lock lug is not fully
engaged, Extend the lift circuit to allow the lock lug to
snap into position.
Crush/Pinch Hazards:
Make sure the lift lock is engaged. Lift and re-lower if it is not.
If the lock lug is not fully seated in the lock plate slots, it may
not engage the pull link lug
, and the implement will slowly
lower after hydraulic power is removed. If anyone is working
on or under the implement, this could result in serious injury
or death.
Fold: Tuck Gauge Wheels (page 40)
Refer to Figure 28
10. Retract the Lift circuit to retract gauge wheels for
transport clearance. Set circuit to neutral to hold
gauge wheels for transport.
Fold: Float Lift Circuit
11. Set Lift circuit to float for transport, parking or
storage. Leave Fold circuit in Neutral.
Figure 27
Lift Lock Engaged
31248
3
4
5
6
3
4 5
6
Figure 28
Tuck (Raise) Gauge Wheels
31144