Great Plains 3S-4000HDF Operator Manual User Manual
Page 22
18
3S-4000HD/HDF
Great Plains Manufacturing, Inc.
195-067M
2013-06-13
Refer to Figure 4 and Figure 5
1.
Adjust the drill hitch to match your tractor-draw bar
height. Mount tongue jack on side of tongue. Use
jack to raise drill tongue so lowest hitch hole is
18 inches (45.7 cm) above ground level with drill
lowered to FIELD position.
Refer to Figure 5
2.
Bolt drill hitch onto drill tongue to match your
tractor-draw bar height. You can turn the hitch over
for a total of six different hitch heights. Always have
two (2) bolts in two holes of both tongue and hitch.
Note: When hitching drill to a different tractor, check for a
difference in draw bar heights. If heights are
different, readjust hitch height accordingly.
3.
Securely attach safety chain to an anchor on a
tractor capable of pulling the drill.
Refer to Figure 6
Use crank to raise jack foot. Remove pin and jack. Store
jack on top of tongue.
Figure 4
Jack in Lifting Location
18941
Figure 5
Heights for Various Hitch Positions - Correct Tongue Height
18956
32.0in
81.3cm
29.0in
73.7cm
26.0in
66.0cm
21.5in
54.6cm
18.5in
47.0cm
15.5in
39.4cm
18.0in
45.7cm
Figure 6
Jack on Storage Stob
18940