Great Plains 3S-4000HDF Operator Manual - Manual (Page 87)

Great Plains Manufacturing, Inc. Table of Contents Index Maintenance and Lubrication 83
2013-06-13 Table of Contents Index 195-067M
Refer to Figure 93 and Figure 94
3. To align the clutch jaws from front to rear, loosen
the two
1 ⁄
2
inch carriage bolts and slide
breakaway clutch bracket in the desired direction.
4. To adjust clutch jaws for full jaw contact, loosen the
same two
1 ⁄
2
inch carriage bolts and slide
breakaway clutch bracket until jaws on the fixed
half of clutch make full contact with jaws on spring
loaded half of clutch without compressing clutch
spring.
Note: The two
7 ⁄
8
inch hex shafts should have
1 ⁄
8
inch
(3.2 mm) gap between them when the clutch
jaws have full contact.
Figure 93
Transfer Drive Shaft Gap
18955
2
1 7 7
Figure 94
Transfer Drive Shaft Horizontal Adjustment
18954
5
4
6
1
5
7
7
1
5
6
5
6
7
2