Great Plains 3S-4000HDF Operator Manual - Manual (Page 86)

82 3S-4000HD/HDF Table of Contents Index Great Plains Manufacturing, Inc.
195-067M Table of Contents Index 2013-06-13
Align Transfer Drive Shaft
Refer to Figure 91 and Figure 92
After wing boxes are properly aligned, the transfer drive
shaft must be aligned so the pair of break-away jaws
are fully engaged and are concentric. The
7 ⁄
8
in hex drive
shafts holding the clutch jaws should not contact each
other
when wing boxes are properly aligned and back
against their stops.
1. Place a 4
×
4 inch (10
×
10 cm) or similar sized block
ahead of the wing gauge wheels and pull forward or
push wing box frames back until the tool bar is firmly
against tool bar stop bolts on the center box frame.
2. To align the clutch jaws vertically, loosen the two
5 ⁄
8
inch bolts on the backside of the adjustment
plate . Slide the plate up or down in the desired
direction. Tighten bolts.
Figure 91
Transfer Drive Jaws
18955
1
2
Figure 92
Transfer Drive Shaft Vertical Adjustment
18953
4
3
4
1
1
2
3
4