Great Plains 3S-4000HDF Operator Manual - Manual (Page 52)

48 3S-4000HD/HDF Table of Contents Index Great Plains Manufacturing, Inc.
195-067M Table of Contents Index 2013-06-13
Total Acres
Refer to Figure 48
Press the FUNC button until the “TOTAL” legend appears
in the display. The digits indicate the acres covered since
the total acre counter was last cleared to zero.
To clear the total acre count, press and hold the UP and
DOWN buttons for 2 seconds.
Note: If a passcode is set, it must be entered to clear the
total acre count.
Total acres count from 1 to 99999 acres.
Pulses per Mile
Press the FUNC button until the “PULSES” legend
appears in the display. The number in the display
indicates shaft rotations for one mile.
Note: If a passcode is set, it must be entered to adjust the
pulses per mile.
There are two methods to enter the pulses per mile.
Known Pulses Values
Refer to Figure 48
1. If you know the number, select it using the UP and
DOWN buttons. When you press the FUNC button,
the controller accepts the number in the display as
the new pulses per mile. Approximate pulses per
mile for 3S-4000HD/HDF row spacings are:
Figure 48
Total Acres Display
26479
2 of 8
Model Spacing Pulses
3S-4000HD/HDFF-4810 10 in 214
3S-4000HD/HDFF-6375 7.5 in 212
3S-4000HD/HDF-7806 6 in 212
Figure 49
Pulses Per Mile Entry
26479
3 of 8