Great Plains 7552 Series VII Operator Manual User Manual
Page 20
Series VII 6326-7552 Discovator 550-221M
3/31/2004
16
Brace Bar, Wing Brace & Rocker/Fold Bracket Assembly
Install the 1 x 7½ or the 1¼ x 9½ eye-
bolt (1) Figure 3, in the mounting bracket at the
back of the wing with a jam nut on each side of
the bracket. Install the 3¼ x 8 (3 3/4 x 8 for
7548 & 7552) rephasing wing cylinder (2)
between the eyebolt and the lever on the wheel
bracket. Pin the cylinder with 1 x 3 clevis pins,
1” machine washers and 3/16 x 2 cotter pin.
Bolt the center brace bar (3) and wing
brace bar (5) to the front of the center frame
and wing frame with ¾ x 2 hex bolts (4) with
lock washers and hex nuts. Do not tighten
bolts. Use a 1 x 6 hex bolt (6) and nylon lock
nut in the hinge. Draw nut tight but do not
torque. Tighten all other bolts evenly to
prevent bind at hinge.
Bolt the front (and rear on larger
models) center fold bracket(s) (7) to the center
frame with two ¾ x 2½ hex bolts (8) with lock
washer and hex nuts.
On 5-section models, bolt the
rocker/fold bracket(s) (9) to the wing using two
¾ x 2½ hex bolts (10) with lock washers and
hex nuts, along with two 5/8 x 3 x 5½ u-bolts
(11) with lock washer and hex nuts. The front
bracket uses a ¾ x 5 bolt (12) to attach the
outer end. The rear bracket uses four 5/8 x 1½
bolts (13) with lock washers and hex nuts to
attach the outer end. Bolt the inside hinge (14)
to the wing brace using 5/8 x 1½ bolts (15) and
one 5/8 x 3 x 5½ u-bolt (16) with lock washers
and hex nuts. On model 6542, bolt the 4” K-
Flex stub (17) to the wing frame using 1/2 x 5½
bolts (18) with lock washers and hex nuts.
3-Section models have rocker bracket
(19), connecting link (20) and connecting link
bracket (21). Assemble with 1 x 3 hex bolts
(22) with 1” lock nuts, ½ x 3 x 5 u-bolts (23)
with lock washers and hex nuts.
Figure 3
2/07/2005