Great Plains 7552 Series VII Operator Manual - Manual (Page 29)

Great Plains Mfg., Inc. Table of Contents ►
Section 1: Assembly
3/31/2004 Series VII 6326-7552 Discovator 550-221M
25
Front Gauge Wheel Assembly
On model 6536 and 7336, bolt the
gauge wheel bracket (1) to the front plate of
wing brace as shown in Figure 13 using the 5/8
x 1½ hex bolts (2), lock washers and hex nuts.
Slide the gauge wheel arm/hub assembly (3)
up into the gauge wheel bracket (1) and pin
with the ¾ x 5¼ usable pin (4). Use four ½ x
1 hex bolts (5) to secure the arm and make it
rigid. Bolt on the 4-bolt rim and tire (6) with
four ½ x 1 lug bolts (7). For directions on the
proper setting for the gauge wheel during
operation, refer to section 5.
Figure 13
2/07/2005