Great Plains NTA3010 Predelivery Manual - Manual (Page 20)

18 NTA3010, NTA3510 and ADC Great Plains Manufacturing, Inc.
160-220M 11/06/2008
Route Hydraulic Hoses
Hoses are pre-assembled on wing and lift-assist cylin-
ders, but need to be routed under clamps on wings and
at rear of center section.
65. Route wing hoses starting from center section. To
allow ample slack for wing folding, length of hose
between clamps on either side of wing pivot region
must be 32 inches (81.3 cm).
66. Check that wing hoses do not rub against sharp
edges, and cannot be pinched or crushed by moving
parts. Allow enough slack at wing gauge wheels for
normal lift/lower operation, and for elevating cylinder
rod end during hydraulic charging.
67. Check that lift-assist hoses do not rub against sharp
edges, and cannot be pinched or crushed by moving
parts. Allow enough slack at wing gauge wheels for
normal lift/lower operation, and for elevating cylinder
rod end during hydraulic charging.
IMPORTANT !
Do not raise, lower or fold implement until hydraulic
system has been charged and bled. See “Charging
Hydraulics” on page 22.
Figure 17
Lift System Hydraulic Hoses
16188
U
D
F
B
L
R
32in
81.3cm
32in
81.3cm